FAST-UXGA
BOARDS
INTRODUCTION
The
Fast-UXGA frame grabber series is for users who anticipate a demand for
extreme I/O requirements or higher bandwidth, complex image processing
and real-time fast storage in a cost effective platform. The base
Fast-UXGA, is a raw-length PCI board with two (four-muxed) UXGA analog
conversion channels using Analog Device's AD9888. The
front end data is formatted and preprocessed by a FPGA before being
sent to the memory subsection, processor, GigE interfaces or other
outputs. Finally, the Fast-UXGA interfaces to the host computer through
a PCI-X or 4x PCIe interface for state-of-the-art data acquisition.
Options include the addition of multiple(8) Serial ATA (SATA) 150
MB/sec interfaces for continuous high-speed data storage without the
usual OS or host bus transfer delays.
ANALOG DEVICES AD9888 FEATURES
The Analog Device's AD9888 has the following features for high speed analog signal aquisition
-
205 MSPS Maximum Conversion Rate
-
500 MHz Programmable Analog Bandwidth
-
0.5 V to 1.0 V Analog Input Range
-
Less than 450 ps p-p PLL Clock Jitter @ 205 MSPS
-
3.3 V Power Supply
-
Full Sync Processing
-
Sync Detect for "Hot Plugging"
-
2:1 Analog Input Mux
-
4:2:2 Output Format Mode
-
Midscale Clamping
-
Power-Down Mode
-
Low Power: <1 W Typical @205 MSPS
FAST-UXGA PCI-X BUS FEATURES
The diagram below outlines
the basic functional section of the FAST-UXGA boards. These are:
- Dual (four muxed) 205 MHz UXGA Analog Device's AD9888 A/D convertors
- Raw PCI form factor
board with 1-2 GB dedicated high speed DDRAM for sustained real-time
on-board storage
- Programmable FPGA and memory subsystem for I/O interface configuration
and processing
- STRETCH 5610 configurable processor for processing
- 133 MHz PCI-X bus interface
- Supported by standard
firmware development tools, including fully optimized basic data
manipulation, data formatting and image processing routines
- Drivers for Windows®
2K/XP, Linux, and Solaris™
click to enlage
OPTIONS
- If sustained high-speed
storage is desired up to eight SATA ports are available on the FAST-Xe version for JBOD
or raided storage of hundreds to thousands of gigabytes of storage
per card.
- Four GigE I/O ports
FAST-UXGA PCI-EXPRESS BUS FEATURES
The diagram below outlines
the basic functional section of the FAST-UXGA boards. These are:
- Dual (four muxed) 205 MHz UXGA A/D convertors
- Raw PCI form factor
board with 1-2 GB dedicated high speed DDRAM for sustained real-time
on-board storage
- Programmable FPGA and memory subsystem for I/O interface configuration
and processing
- STRETCH 5610 configurable processor for processing
- PCIe x4 bus interface
- Supported by standard
firmware development tools, including fully optimized basic data
manipulation, data formatting and image processing routines
- Drivers for Windows®
2K/XP, Linux, and Solaris™
click to enlarge
OPTIONS
- If sustained high-speed
storage is desired up to eight SATA ports are available on the FAST-Xe version for JBOD
or raided storage of hundreds to thousands of gigabytes of storage
per card
-
Four GigE I/O ports
Click here
to Download Datasheets or here
to Register to Download Manuals
To
Top of Page |
